The destabilising effects of various cations on a surfactant derivative of poly iso-butenyl succinic anhydride.

Abstract

The interfacial behaviour of two amphiphillic poly iso-butenyl succinic anhydride (PIBSA)-derived surfactants and the effect of their interaction with various nitrate salts on the stability of a water-in-oil type emulsion has been investigated. The adsorption of the esterification product of PIBSA and coco-diethanolamide (PICDEA) and of Experse-70 (E-70) at the equilibrated aqueous-fuel oil interface was investigated via the measurement of interfacial tension using the ring detachment method.The interfacial pressure of PICDEA decreased in the presence of excess unreacted coco-diethanolamide (CDE) and for both PICDEA and E-70 interfacial pressure decreased with an increase in the length of the poly iso-butenyl (PIB) hydrocarbon tail. Interfacial tension-concentration curves and the Gibbs Equation were used to determine surfactant surface excess concentration and the packing efficiency of the surfactant in the interphase. The double hydrocarbon PICDEA molecule was found to occupy a larger interfacial area than the single hydrocarbon E-70 molecule. The pH of the aqueous phase effects the interfacial activity and nature of, PICDEA and E-70 at the interface. PICDEA is protonated at pH values less than 4.6 and deprotonated at higher pH values. E-70 is neutral at low pH and deprotonated at pH values greater than approximately 2.The effect of sodium, calcium and ferric nitrate salts on the interfacial free energy of the surfactant saturated interface was also determined. The interfacial tension at the E-70 aqueous nitrate interface was dependent on ionic strength alone with a general decrease in interfacial free energy as nitrate concentration was increased. In the case of PICDEA, however, a surfactant-cation orientation effect was observed. The divalent Ca2+ cation attracts two adjacent PICDEA anions resulting in the adverse interaction of hydrocarbon tails in the interphase. This produces an interface with a higher than expected interfacial free energy. The Na+ cation produces an interface with a more energetically stable orientation. PICDEA in the presence of a ferric nitrate solution (pH 1 to 2) is protonated and therefore the univalent nitrate anion forms the counterion layer at the positively charged surfactant interface. Stability studies were carried out on aqueous nitrate salt in diesel emulsions using PICDEA as the stabilizing surfactant. Droplet coalescence rates were determined from droplet size distribution data in the presence of varying concentrations of sodium, calcium and ferric nitrate salts. Droplets were sized microscopically at progressive time intervals and the rate of coalescence determined from the change in droplet concentration with time. Coalescence was found to follow two or more consecutive first order reactions. After an initial period of rapid droplet coalescence, involving small droplets with diameters of 5~m and less, a droplet distribution is attained conducive to a more stable emulsion which then undergoes a slower rate of coalescence involving larger droplets. The effect of the nitrate salt type on the initial droplet coalescence rate (in order of increasing rate) is as follows: Ca2+< Na+< Fe3+. The opposite trend was observed for the slower long term rate of coalescence, i.e. Fe3+< Na+< Ca2+. These trends are explained in terms of the surfactant cation orientation effect, the effect of the droplet's radius of curvature on the potential energy barrier against coalescence and the effect of the droplet distribution of the emulsion system.