Development of an advanced generation breeding strategy for Eucalyptus Nitens (Deanne and Maiden) Maiden.
MetadataShow full item record
The objective of this study was to develop and implement an advanced generation breeding programme at the Institute for Commercial Forestry Research (ICFR) to manage and integrate the many and disjunct breeding and production populations of Eucalyptus nitens established by various entities over the past 30 years at multiple sites in South Africa. To develop such a breeding strategy, a good understanding of the population genetics, and the underlying assumptions made by tree breeders about the species, was needed. Eucalyptus nitens is an important forestry species grown for pulp and paper production in the temperate, summer rainfall regions of South Africa. A tree improvement programme has been ongoing at the ICFR for three decades. The measurement and statistical analysis of data from eight F1 trials established during the 1980s and 1990s have enabled characterisation of the ICFR’s breeding population. Provenance testing showed that the more northerly New South Wales (Australia) Eucalyptus nitens provenances of Barren Mountain and Barrington Tops are distinctly better suited to growth in South Africa than the southern New South Wales provenances and the Victorian provenances, Penny Saddle and Bendoc. Generally, the species was not badly affected by Coniothyrium canker. High Type B genetic correlations for all sites pairs, except one comparison, ranged from 0.75 to 0.99 for diameter at breast height at 76 to 113 months, indicating very little, or no, genotype by environment interaction for diameter at breast height for the genotypes tested in the F1 generation. Narrow sense heritability estimates ranged from 0.01 to 0.34, indicating that the species provides a breeding opportunity for improvement of diameter growth. High genetic correlations of greater than 0.90 between diameter measurements at 52 to 62 months after establishment and diameter measurements at 94 or 113 months were found, indicating that selections can be made reliably at five or six years. Diameter measurements at both 60 months and full rotation (94 to 113 months) were highly correlated with the final height measurements in these trial series (rg > 0.71 and > 0.83, respectively). Predicted genetic gains for the F2 over the F1 generation were highest in the trials at Goedehoop and Arthur’s Seat, with predicted increases in diameter at breast height of 3.07 cm (17.1%) and 3.17 cm (20.7%), respectively, at full rotation. Genetic improvement in the species has been slower than anticipated due to delayed and infrequent flowering and seed production. Three genetic gain trials were established, firstly, to quantify the gains that have been made in the first generation of improvement in the breeding programme; and secondly, to establish whether a number of seed source and orchard variables influence the performance of the progeny. These variables were: the number of flowering trees in the seed orchard, year of seed collection, seed orchard origin and composition of seed orchard seed bulks. Diameter at breast height and tree height were measured in the trials at between 87 and 97 months after establishment, and timber volumes and survival were calculated. Improved seed orchard bulks performed significantly better (p < 0.01) than unimproved controls in the field trials, and genetic gains ranging from 23.2 to 164.8 m3ha-1 were observed over the unimproved commercial seed. There were significant differences (p < 0.01) in progeny growth between the levels of flowering, with higher levels of flowering (R 40 %) producing substantially greater progeny growth than lower flowering levels (S 20 %). The seed orchard origin had no effect on progeny growth in this trial series. This suggests that seed collected from any of the four seed orchards tested will produce trees with significant improvement in growth. Various scenarios investigating a range of assumptions were developed and used to predict genetic gain in the F2 populations. These were compared with realised gains achieved in the genetic gain trials. The family nested within provenance scenarios proved to be closer to realised gain than the family across provenance predictions. Two scenarios were used for family nested within provenance: Firstly, actual flowering for family nested within provenance; and secondly, estimated flowering after a 30% roguing of poor families. For both scenarios, a coefficient of relationship of 0.33 predicted gains closest to the realised gains. Indications were that the effects were additive, and that very little or no heterosis had occurred. The statistical information suggested that outcrossing in the seed orchards was > 80%. This study provides an objective and quantitative assessment of the underlying assumptions used for estimating genetic parameters, and predicting gain in this population of Eucalyptus nitens. At the same time that genetic gain trials were established, F2 trials were planted, using seedlots collected from F1 seed orchards. Analysis of the two F2 trials showed that realised gains for diameter at breast height at 87 months were close to the predicted values and ranged from 1.02 cm to 1.90 cm. Two exceptions were the sites at Helvetia and Babanango, where gains were under- and over-predicted, respectively. Realised heritability estimates, which are related directly to the realised gain and the actual selection intensities used in the seed orchards, reflected this trend. Estimation of breeding values allowed for selection of elite individuals in top families. Both grand-maternal provenance origin and F1 maternal effects were significant in the F2 trials. A Type B genetic correlation of 0.61 for diameter at 87 months indicated the possible presence of genotype by environment interactions for the two F2 sites. A low narrow sense heritability estimate of 0.06 for diameter at breast height at 87 months at one F2 site indicated that more emphasis should be placed on family information rather than individual information at this site. A heritability estimate of 0.17 for diameter at breast height at 87 months at the second site, however, indicated that further improvement is possible in this population of Eucalyptus nitens. Modelling of predicted genetic gain using various breeding strategy scenarios can be a useful tool in assisting with the decision on which strategy or management plan will deliver the most genetic gains per unit time. Such modelling, using the parameters established in the first part of the study, played an important role in developing the advanced generation breeding strategy for Eucalyptus nitens. In addition, the modelling exercise highlighted various management options which could be used to increase gains in the existing production populations or orchards. Indications are that additional roguing of 1) existing Clonal Seed Orchards based on results of F2 trials (i.e., backward selection); and 2) F1 Breeding Seed Orchards based on stricter provenance selection, will markedly increase the quality of the seed produced from these orchards within one season. This study also highlighted the importance of shortening the breeding cycle in Eucalyptus nitens, particularly in view of the delays caused by reticent flowering and seed production in the species. The information and understanding gathered from this study led to the development of a proposal for an advanced generation breeding strategy in Eucalyptus nitens. This proposal uses parental reconstruction of open-pollinated progeny to secure pedigree information of forward selections, thus combining the benefits of increased genetic gain with a shortened breeding cycle. Recommendations on the management and adaption of current production populations to increase gains have been made, because establishment and management of improved material in seed orchards to ensure a sustainable supply of improved seed to the South African forestry industry, is a key objective of the ICFR Eucalyptus nitens breeding programme.
Showing items related by title, author, creator and subject.
Genetic and environmental factors affecting rooting in Eucalyptus grandis X Eucalyptus longirostrata hybrid cuttings. Naidoo, Nuveshen. (2011)In clonal deployment programmes of plantation species, there is frequently the need to deploy Eucalyptus species and interspecific hybrids as rooted cuttings. However, the rooting ability of a particular species or hybrid ...
The effect of genetic improvement, fertilisation, weed control and regeneration method on the establishment and performance of Eucalyptus macarthurii and Eucalyptus nitens. Van den Berg, Gerhardus Johannes. (2005)Eucalyptus grandis was introduced into South Africa in the 19th century, and has since become the most important of the hardwood plantation tree species grown for pulp. Until the late 1980's E. grandis was virtually the ...
The estimation of Eucalyptus plantation forest structural attributes using medium and high spatial resolution satellite imagery. Gebreslasie, Michael T. (2008)Sustaining the socioeconomic and ecological benefits of South African plantation forests is challenging. A more systematic and rapid forest inventory system is required by forest managers. This study investigates the utility ...